16. Hill-holder System
SA07735
A: INSPECTION AND ADJUSTMENT
SA07735G26
1) Confirm stopping and starting performance by activating hill-holder on an uphill road of 3° or higher inclination.
(1) When vehicle does not stop; Tighten adjusting nut of PHV cable.
(2) When vehicle does not start properly;
A; When hill-holder is released later than engagement of clutch (engine tends to stall): Loosen adjusting nut gradually until smooth starting is enabled.
B; When hill-holder is released earlier than engagement to clutch (vehicle slips down slightly): Tighten adjusting nut so that hill-holder is released later than engagement of clutch (status in A). Then make adjustment the same as in A.
NOTE:
- Whenever turning adjusting nut, hold inner cable with pliers to prevent it from turning.
- Replace pressure hold valve (PHV), return spring of PHV or PHV cable with new one, if they are defective and/or damaged.