CLEAR MEMORY MODE
Engine (Diagnostics)
13. Clear Memory Mode
S088513
3. OBD-II GENERAL SCAN TOOL
S088513A1603
A: OPERATION
S088513A16
For clear memory procedures using the OBD-II general scan tool, refer to the OBD-II General Scan Tool Instruction Manual.
1.  SUBARU SELECT MONITOR (NORMAL
MODE) S088513A1601
1)  On the
display screen, select the {2. Each System Check} and press the [YES] key.
2)  On the ^System Selection Menu> display screen, select the {Engine Control System} and press the [YES] key.
3)   Press the [YES] key after displayed the information of engine type.
4)  On the ^Engine Diagnosis^ display screen, select the {Clear Memory} and press the [YES] key.
5)  When the 'Done' and Turn Ignition Switch OFF' are shown on the display screen, turn the Subaru Select Monitor and ignition switch to OFF.
NOTE:
   For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.
2.   SUBARU SELECT MONITOR (OBD
MODE) S088513A1602
1)  On the
display screen, select the {2. Each System Check} and press the [YES] key.
2)  On the ^System Selection Menu> display screen, select the {Engine Control System} and press the [YES] key.
3)   Press the [YES] key after displayed the information of engine type.
4)  On the ^Engine Diagnosis^ display screen, select the {OBD System} and press the [YES] key.
5)  On the display screen, select the {4. Diagnosis Code(s) Cleared} and press the [YES] key.
6)  When the 'Clear Diagnostic Code?' is shown on the display screen, press the [YES] key.
7)  Turn Subaru Select Monitor and ignition switch to OFF.
NOTE:
   For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.
EN(DOHC TURBO)-47