FUEL DELIVERY, RETURN AND EVAPORATION LINES
Fuel Injection (Fuel Systems)
24. Fuel Delivery, Return and
2)  Open fuel filler flap lid and remove fuel filler cap.
3)   Remove inner trim, insulator and rear seat.
4)   Remove fuel delivery pipes and hoses, fuel return pipes and hoses, evaporation pipes and hoses.
Evaporation Lines
S165019
A: REMOVAL
S165019A18
1) Release fuel pressure. <Ref. to FU(SOHCw/ oOBD)-41, RELEASING OF FUEL PRESSURE, OPERATION, Fuel.>
for_01_21-231.jpg
5) In engine compartment, detach fuel delivery hoses, return hoses and evaporation hose.
7) Separate quick connector on fuel delivery and return line.
(1)  Clean pipe and connector, if they are cov­ered with dust.
(2)   Hold connector (A) and push retainer (B) down.
(3)   Pull out connector (A) from retainer (B).
CAUTION:
Replace retainer with new ones.
for_01_21-232.jpg
for_01_21-233.jpg
6) In the engine compartment, detach canister hose from canister.
for_01_21-234.jpg
(A)    Connector
(B)     Retainer
(C)    Pipe
FU(SOHCw/oOBD)-56
FUEL DELIVERY, RETURN AND EVAPORATION LINES
Fuel Injection (Fuel Systems)
B: INSTALLATION
S165019A11
CAUTION:
  Pull the connector to ensure it is connected securely.
  Ensure the two retainer pawls are engaged in their mating positions in the connector.
  Be sure to inspect hoses and their connec­tions for any leakage of fuel.
1) Connect quick connector on fuel delivery and return line.
CAUTION:
  Always use a new retainer.
   Make sure that the connected portion is not damaged or has dust. If necessary, clean seal surface of pipe (A).
for_01_21-235.jpg
for_01_21-236.jpg
(A)    Connector
(B)     Retainer
(C)    Pipe
2) Connect fuel delivery hose to pipe with an over­lap of 20 to 25 mm (0.79 to 0.98 in). Type A: When fitting length is specified. Type B: When fitting length is not specified.
t : 2.5±1.5 mm (0.098±0.059 in) L: 22.5±2.5 mm (0.886±0.098 in)
(1)  Set new retainer (B) to connector (A).
(2)   Push pipe into connector completely.
NOTE:
At this time, two clicking sounds are heard.
for_01_21-237.jpg
for_01_21-238.jpg
(A)    Connector
(B)     Retainer
(C)    Pipe
(1)     Fitting
(2)     Clamp
(3)     Hose
FU(SOHCw/oOBD)-57
FUEL DELIVERY, RETURN AND EVAPORATION LINES
Fuel Injection (Fuel Systems)
3) Connect evaporation hose to pipe by approx. 15 mm (0.59 in) from hose end.
L = 17.5±2.5 mm (0.689±0.098 in)
CAUTION:
Be sure to inspect hoses and their connections
for any leakage of fuel.
for_01_21-239.jpg
(1)     Hose
(2)     Clip
(3)     Pipe
C: INSPECTION
S165019A10
1)   Make sure that there are no cracks on the fuel pipes and fuel hoses.
2)   Make sure that the fuel pipe and fuel hose con­nections are tight.
FU(SOHCw/oOBD)-58