FUEL PUMP
Fuel Injection (Fuel Systems)
19. Fuel Pump
S165025
7)   Move clips, and then disconnect fuel delivery hose (A), return hose (B) and jet pump hose (C).
8)   Disconnect quick connector, and then discon­nect fuel delivery hose (A). <Ref. to FU(SOHCw/ oOBD)-56, REMOVAL, Fuel Delivery, Return and Evaporation Lines.>
A: REMOVAL
S165025A18
WARNING:
  Place "No fire" signs near the working area.
  Be careful not to spill fuel on the floor.
1)   Release fuel pressure. <Ref. to FU(SOHCw/ oOBD)-41, RELEASING OF FUEL PRESSURE, OPERATION, Fuel.>
2)  Open fuel filler flap lid, and remove fuel filler cap.
3)   Disconnect battery ground cable.
for_01_21-210.jpg
for_01_21-211.jpg
9) Remove nuts which install fuel pump assembly onto fuel tank.
for_01_21-212.jpg
4)   Remove the floor box located just behind the rear seats.
5)   Remove access hole lid.
for_01_21-213.jpg
10) Take off fuel pump from fuel tank.
for_01_21-214.jpg
6) Disconnect connector from fuel pump.
for_01_21-215.jpg
FU(SOHCw/oOBD)-50
FUEL PUMP
Fuel Injection (Fuel Systems)
B: INSTALLATION
S165025A11
Install in the reverse order of removal. Do the fol­lowing:
(1)  Always use new gaskets.
(2)   Ensure sealing portion is free from fuel or for­eign particles before installation.
(3)  Tighten nuts in alphabetical sequence shown in Figure to specified torque.
Tightening torque:
4.4 Nm (0.45 kgf-m, 3.3 ft-lb)
for_01_21-216.jpg
C: INSPECTION
S165025A10
Connect lead harness to connector terminal of fuel pump, and apply battery power supply to check whether the pump operate.
WARNING:
  Wipe off the fuel completely.
  Keep battery as far apart from fuel pump as possible.
  Be sure to turn the battery supply ON and OFF on the battery side.
  Do not run fuel pump for a long time under non-load condition.
for_01_21-217.jpg
FU(SOHCw/oOBD)-51