GENERAL DESCRIPTION
Exhaust
1. General Description
S152001
A: COMPONENT
S152001A05
for_01_14-2.jpg
S2M2132A
EX(SOHC)-2
GENERAL DESCRIPTION
Exhaust
(1)    Upper front exhaust pipe cover               (10) Lower center exhaust pipe cover             (21) Gasket CTR                                                          (11) Gasket                                                      (22) Self-lock nut
(2)    Lower front exhaust pipe cover               (12) Upper rear catalytic converter                  (23) Muffler
CTR                                                                  cover                                                        (24) Cushion rubber
(3)    Front exhaust pipe                                   (13) Lower rear catalytic converter                 _________________
(4)    Front oxygen (A/F) sensor cover                                                        Tightening torque: Nm (kgf-m, ft-lb)
(5)    Front catalytic converter                          (14) Rear catalytic converter                                T1: 8 (0.8, 5.8)
(6)    Upper front catalytic converter                 (15) Center exhaust pipe                                      T2: 13 (1.3, 9.4) cover                                                        (16) Protector                                                        T3: 18 (1.8, 13.0)
(7)    Lower front catalytic converter               (17) Rear oxygen sensor                                  T4:30(3. 1 22 4) cover                                                        (18) Gasket                                                           r5. 35 (3 .6, 26. 0)
(8)    Clamp                                                       (19) Spring                                                            T6: 48 (4.9, 35.4)
(9)    Upper center exhaust pipe cover             (20) Rear exhaust pipe                                   ______________________________
EX(SOHC)-3
GENERAL DESCRIPTION
Exhaust
B: CAUTION
S152001A03
-  Wear working clothing, including a cap, protec­tive goggles, and protective shoes during opera­tion.
-   Remove contamination including dirt and corro­sion before removal, installation or disassembly.
-   Keep the disassembled parts in order and pro­tect them from dust or dirt.
-   Before removal, installation or disassembly, be sure to clarify the failure. Avoid unnecessary removal, installation, disassembly, and replace­ment.
-   Be careful not to burn your hands, because each part on the vehicle is hot after running.
-   Be sure to tighten fasteners including bolts and nuts to the specified torque.
-   Place shop jacks or safety stands at the speci­fied points.
-   Before disconnecting electrical connectors of sensors or units, be sure to disconnect negative terminal from battery.
EX(SOHC)-4