7. Knock Sensor

S155042

A: REMOVAL

S155042A18

1) Disconnect battery ground cable from battery ground terminal.

2) Remove air cleaner case.

3) Disconnect knock sensor connector.

4) Remove knock sensor from cylinder block.

B: INSTALLATION

S155042A11

1) Install knock sensor to cylinder block.

Tightening torque:

24 Nm (2.4 kgf-m, 17.4 ft-lb)

NOTE:

The extraction area of the knock sensor cord must

be positioned at a 60° angle relative to the engine

rear.

2) Connect knock sensor connector.

3) Install air cleaner case.

4) Connect battery ground cable.