FUEL PUMP
Fuel Injection (Fuel Systems)
22. Fuel Pump
S155025
6) Disconnect connector from fuel pump.
A: REMOVAL
S155025A18
for_01_10_22-1.jpg
WARNING:
-  Place "No fire" signs near the working area.
-  Be careful not to spill fuel on the floor.
1)   Release fuel pressure. <Ref. to FU(SOHC)-52, RELEASING OF FUEL PRESSURE, OPERATION, Fuel.>
2)  Open fuel filler flap lid, and remove fuel filler cap.
for_01_10_22-2.jpg
7)   Move clips, and then disconnect fuel delivery hose (A), return hose (B) and jet pump hose (C).
8)   Disconnect quick connector, and then discon­nect fuel delivery hose (A). <Ref. to FU(SOHC)-69, REMOVAL, Fuel Delivery, Return and Evaporation Lines.>
for_01_10_22-3.jpg
3) Disconnect battery ground cable.
for_01_10_22-4.jpg
9) Remove nuts which install fuel pump assembly onto fuel tank.
for_01_10_22-5.jpg
4)   Remove the floor box located just behind the rear seats.
5)   Remove access hole lid.
for_01_10_22-6.jpg
10) Take off fuel pump from fuel tank.
for_01_10_22-7.jpg
FU(SOHC)-62
FUEL PUMP
Fuel Injection (Fuel Systems)
B: INSTALLATION
S155025A11
Install in the reverse order of removal. Do the fol­lowing:
(1)  Always use new gaskets.
(2)   Ensure sealing portion is free from fuel or for­eign particles before installation.
(3)  Tighten nuts in alphabetical sequence shown in the figure to specified torque.
Tightening torque:
4.4 Nm (0.45 kgf-m, 3.3 ft-lb)
for_01_10_22-8.jpg
C: INSPECTION
S155025A10
Connect lead harness to connector terminal of fuel pump, and apply battery power supply to check whether the pump operate.
WARNING:
-  Wipe off the fuel completely.
-  Keep battery as far apart from fuel pump as possible.
-  Be sure to turn the battery supply ON and OFF on the battery side.
-  Do not run fuel pump for a long time under non-load condition.
for_01_10_22-9.jpg
FU(SOHC)-63