2001 СУБАРУ ФОРЕСТЕР. Руководство по обслуживанию

FUEL

Fuel Injection (Fuel Systems)

				3) Disconnect battery ground cable.
	S185052			3) Disconnect battery ground cable.
21. Fuel

A: OPERATION		S185052A16
1. RELEASING OF FUEL PRESSURE
S185052A1601
WARNING: • Place "NO FIRE" signs near the working area. • Disconnect ground terminal from battery. 1) Disconnect connector from fuel pump relay.

			4) Remove the floor box located just behind the rear seats. 5) Remove access hole lid.

2) Start the engine, and run it until it stalls. 3) After the engine stalls, crank it for five more seconds. 4) Turn ignition switch to OFF. 2. DRAINING OF FUEL S₁8⁵052A16₀3 WARNING: • Place "NO FIRE" signs near the working area. • Be careful not to spill fuel on the floor. 1) Release fuel pressure. <Ref. to FU(DOHC TURBO)-50, RELEASING OF FUEL PRESSURE, OPERATION, Fuel.> 2) Open fuel flap lid, and remove fuel filler cap.
				6) Disconnect connector from fuel pump.


			7) Disconnect quick connector, and then disconnect fuel delivery hose (A). <Ref. to FU(DOHC TURBO)-67, REMOVAL, Fuel Delivery, Return and Evaporation Lines.>

FU(DOHC TURBO)-50



FUEL

Fuel Injection (Fuel Systems)

8) Move clips, and then disconnect fuel return 12) Remove service hole cover, hose (B) and jet pump hose (C).

		13) Disconnect connector from fuel sub level sensor. 14) Disconnect fuel jet pump hose.
9) Remove nuts which install fuel pump assembly onto fuel tank.



10) Take off fuel pump from fuel tank.	15) Remove bolts which install fuel sub level sensor on fuel tank.


11) Drain fuel from fuel tank by using a hand pump. 16) Remove fuel sub level sensor. WARNING: Do not use a motor pump when draining fuel.



FU(DOHC TURBO)-51



	FUEL Fuel Injection (Fuel Systems)

	17) Drain fuel from there. WARNING: Do not use a motor pump when draining fuel.



	FU(DOHC TURBO)-52