Fuel Injection (Fuel Systems)
FRONT OXYGEN (A/F) SENSOR
15. Front Oxygen (A/F) Sensor
6) Remove service hole cover.
S185642
for_01_22-146.jpg
A: REMOVAL
S185642A18
1) Disconnect battery ground cable.
for_01_22-147.jpg
7)  Apply SUBARU CRC or its equivalent to threaded portion of front oxygen (A/F) sensor, and leave it for one minute or more.
SUBARU CRC (Part No. 004301003)
8)   Remove front oxygen (A/F) sensor.
CAUTION:
When removing the oxygen (A/F) sensor, wait until exhaust pipe cools, otherwise it will dam­age exhaust pipe.
2) Disconnect connector from front oxygen (A/F) sensor.
for_01_22-148.jpg
for_01_22-149.jpg
3) Remove harness secured by clip (A) from the bracket (B).
for_01_22-150.jpg
4)   Remove front right side wheel.
5)   Lift-up the vehicle.
FU(DOHC TURBO)-42
FRONT OXYGEN (A/F) SENSOR
Fuel Injection (Fuel Systems)
B: INSTALLATION
S185642A11
7) Connect connector of front oxygen (A/F) sen­sor.
1)   Before installing front oxygen (A/F) sensor, apply anti-seize compound only to threaded por­tion of front oxygen (A/F) sensor to make the next removal easier.
Anti-seize compound: SS-30 by JET LUBE
CAUTION:
Never apply anti-seize compound to protector
of front oxygen (A/F) sensor.
2)   Install front oxygen (A/F) sensor.
Tightening torque:
30Nm (3.1 kgf-m, 22 ft-lb)
for_01_22-151.jpg
8) Connect battery ground cable.
for_01_22-152.jpg
for_01_22-153.jpg
3) Install service hole cover.
for_01_22-154.jpg
4)   Lower the vehicle.
5)   Install front right side wheel.
6)  Secure a harness to bracket (B) by clip (A).
for_01_22-155.jpg
FU(DOHC TURBO)-43