CRANKSHAFT PULLEY
Mechanical
13. Crankshaft Pulley
S183098
CAUTION:
If the tightening angle of crankshaft pulley bolt
is less than 45 degrees, the bolt should be
damaged. In this case, the bolt must be
replaced.
(1)   Replace the crankshaft pulley bolts and clean them.
Crankshaft pulley bolt: 12369AA011
(2)  Clean the crankshaft thread using an air gun.
(3)  Tighten the bolts temporarily with tightening torque of 44 Nm (4.5 kgf-m, 33 ft-lb).
(4)  Tighten the crankshaft pulley bolts keeping them in an angle between 65 degrees and 75 degrees.
CAUTION:
Conduct the tightening procedures by confirm­ing the turning angle of the crankshaft pulley bolt referring to the gauge indicated on the belt cover.
4) Install A/C belt tensioner.
A: REMOVAL
S183098A18
1)   Remove V-belt. <Ref. to ME(DOHC TURBO)-44, REMOVAL, V-belt.>
2)   Remove crankshaft pulley bolt. To lock crankshaft, use ST.
ST 499977300
CRANKSHAFT PULLEY WRENCH
for_01_22-425.jpg
3) Remove crankshaft pulley.
B: INSTALLATION
S183098A11
for_01_22-426.jpg
1)   Install crankshaft pulley.
2)   Install pulley bolt.
To lock crankshaft, use ST. ST 499977300 CRANKSHAFT PULLEY WRENCH
(1)  Clean the crankshaft pulley thread using an air gun.
(2)  Apply engine oil to the crankshaft pulley bolt seat and thread.
(3)  Tighten the bolts temporarily with tightening torque of 44 Nm (4.5 kgf-m, 33 ft-lb).
(4)  Tighten the crankshaft pulley bolts.
Tightening torque:
127 Nm (13.0 kgf-m, 94.0 ft-lb)
5) Install A/C belt.
for_01_22-427.jpg
for_01_22-428.jpg
C: INSPECTION
S183098A10
1)   Make sure the V-belt is not worn or otherwise damaged.
2)  Check the tension of the belt. <Ref. to ME(DOHC TURBO)-45, INSPECTION, V-belt.>
3) Confirm that the tightening angle of the crank­shaft pulley bolt is 45 degrees or more. If not, con­duct the following procedures (1) through (4).
ME(DOHC TURBO)-46