V-BELT
|
||||||||
|
||||||||
Mechanical
|
||||||||
|
||||||||
12. V-belt
|
S183080
|
3) Remove the A/C belt.
4) Remove the A/C belt tensioner.
|
||||||
|
||||||||
A: REMOVAL
|
S183080A18
|
|
||||||
1. FRONT SIDE BELT
NOTE:
Perform the following procedures 1) to 4) with the
engine installed to the body.
1) Remove V-belt cover.
|
||||||||
|
|
|||||||
B: INSTALLATION 1. FRONT SIDE BELT
|
S183080A11
|
|||||||
S183080A1101
|
||||||||
CAUTION:
Wipe off any oil or water on the belt and pulley.
1) Install a belt, and tighten the slider bolt so as to obtain the specified belt tension <Ref. to ME(DOHC TURBO)-45, INSPECTION, V-belt.>
2) Tighten the lock bolt (A)
3) Tighten slider bolt (B).
Tightening torque: Lock bolt through bolt:
25 N-m (2.5 kgf-m, 18 ft-lb) Slider bolt:
8 N-m (0.8 kgf-m, 5.5 ft-lb)
|
||||||||
2) Loosen the lock bolt (A).
3) Loosen the slider bolt (B).
4) Remove the front side belt (C).
|
||||||||
|
||||||||
|
|
|||||||
2. REAR SIDE BELT
|
S183080A1802
|
|||||||
1) Loosen the lock nut (A).
2) Loosen the slider bolt (B).
|
||||||||
|
||||||||
|
||||||||
ME(DOHC TURBO)-44
|
||||||||
|
||||||||
|
|||||
V-BELT
|
|||||
|
|||||
Mechanical
|
|||||
|
|||||
2. REAR SIDE BELT
|
S183080A1102
|
C: INSPECTION
|
S183080A10
|
||
|
|||||
1) Install a belt, and tighten the slider bolt (B) so as to obtain the specified belt tension. <Ref. to ME(DOHC TURBO)-45, INSPECTION, V-belt.>
2) Tighten the lock nut (A).
Tightening torque: Lock nut (A);
22.6 Nm (2.3 kgf-m, 16.6 ft-lb)
|
1) Replace belts, if cracks, fraying or wear is found.
2) Check drive belt tension and adjust it if necessary by changing generator installing position and/or idler pulley installing position.
Belt tension (A)
replaced: 7—9 mm (0.276 — 0.354 in) reused: 9—11 mm (0.354 — 0.433 in) (B)*
replaced: 7.5 — 8.5 mm (0.295 — 0.335 in)
reused: 9.0 — 10.0 mm (0.354 — 0.394 in) *: With Air conditioner
|
||||
|
|||||
|
|||||
|
|||||
C/P Crankshaft pulley
GEN Generator
P/S Power steering oil pump pulley
A/C Air conditioning compressor pulley
I/P Idler pulley
|
|||||
|
|||||
ME(DOHC TURBO)-45
|
|||||
|
|||||
|