|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Fuel Injection (Fuel Systems)
|
|
|
|
|
|
|
|
|
|
(6) Adjust throttle position sensor so that signal voltage on CHECK BOARD may be in specification.
Terminal / Specified voltage
(C) No. 23 - (C) No. 24 / 0.45 -0.55 V [Fully closed.]
|
|
|
|
1) Turn ignition switch to OFF.
2) Loosen throttle position sensor holding screws.
|
|
|
|
|
|
|
|
|
|
|
|
3) When using voltage meter;
(1) Disconnect battery ground cable.
|
|
|
|
|
|
|
|
|
(7) Tighten throttle position sensor holding screws.
Tightening torque:
1.6 Nm (0.16 kgf-m, 1.2 ft-lb)
CAUTION:
When removing ST from ECM, disconnect battery ground cable.
|
|
|
|
|
|
|
|
(2) Disconnect connectors from ECM.
|
|
|
|
|
|
|
|
4) When using Subaru Select Monitor;
NOTE:
For detailed operation procedures, refer to the
Subaru Select Monitor Operation Manual.
(1) Insert the cartridge to Subaru Select Monitor. <Ref. to FU(SOHCw/oOBD)-10, PREPARATION, General Description.>
|
|
|
|
(3) Set ST to ECM.
ST 498307600 CHECK BOARD KIT
(4) Connect battery ground cable.
(5) Turn ignition switch to ON.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Fuel Injection (Fuel Systems)
|
|
|
|
|
|
|
|
(2) Connect Subaru Select Monitor to the data link connector.
(3) Turn ignition switch to ON, and Subaru Select Monitor switch to ON.
(4) Select {2. Each System Check} in Main Menu.
(5) Select {Engine Control System} in Selection Menu.
(6) Select {1. Current Data Display & Save} in Engine Diagnosis.
(7) Select {1.12 Data Display} in Data Display Menu.
(8) Adjust throttle position sensor to the proper position to match with the following specifications.
Condition: Throttle fully closed Throttle opening angle 0.00% Throttle sensor voltage 0.50 V
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
(9) Tighten throttle position sensor holding screws.
Tightening torque:
1.6 Nm (0.16 kgf-m, 1.2 ft-lb)
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
