KNOCK SENSOR
Fuel Injection (Fuel Systems)
6. Knock Sensor
S165042
B: INSTALLATION
S165042A11
A: REMOVAL
S165042A18
1) Install knock sensor to cylinder block.
Tightening torque:
24 Nm (2.4 kgf-m, 17.4 ft-lb)
NOTE:
The extraction area of the knock sensor cord must
be positioned at a 60° angle relative to the engine
rear.
1) Disconnect battery ground cable from battery ground terminal.
2) Remove air cleaner case.
<Ref. to IN(SOHC)-7, REMOVAL, Air Cleaner Case.>
3) Disconnect knock sensor connector.
2) Connect knock sensor connector.
4) Remove knock sensor from cylinder block.
3) Install air cleaner case.
<Ref. to IN(SOHC)-7, INSTALLATION, Air Cleaner Case.>
4) Connect battery ground cable.
FU(SOHCw/oOBD)-25