CLEAR MEMORY MODE
Engine (Diagnostics)
9. Clear Memory Mode
S068513
A: OPERATION
S068513A16
1. WITH SUBARU SELECT MONITOR
S068513A1601
1)  On the <§Main Menu> display screen, select the {2. Each System Check} and press the [YES] key.
2)  On the ^System Selection Menu> display screen, select the {Engine Control System} and press the [YES] key.
3)   Press the [YES] key after displayed the information of engine type.
4)  On the ^Engine Diagnosis^ display screen, select the {Clear Memory} and press the [YES] key.
5)  When the 'Done' and Turn Ignition Switch OFF' are shown on the display screen, turn the Subaru Select Monitor and ignition switch to OFF.
NOTE:
•  After the memory has been cleared, the ISC must be initialized. To do this, turn the ignition switch to the ON position. Wait 3 seconds before starting the engine.
•   For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.
2. WITHOUT SUBARU SELECT MONITOR
S068513A1602
No.
Step
Check
Yes
No
1
CHECK STATUS OF CHECK ENGINE MAL­FUNCTION INDICATOR LAMP (MIL).
1) Turn ignition switch to OFF. 2) Set shift lever to neutral position (MT vehicles), or set selector lever to "P" position (AT vehicles). 3) Connect test mode connector and read memory connector. 4) Turn ignition switch to ON.
Does the MIL come on?
Go to step 2.
Check the follow­ing and repair if necessary. NOTE: • Open or short circuit in engine control module power supply or ground line • Open or short circuit in CHECK ENGINE malfunc­tion indicator lamp
2
CHECK DIAGNOSTIC TROUBLE CODE (DTC).
1) Set selector lever to "N" position, and then set selector lever to "P" position again (AT vehicles only). 2) Start the engine. 3) Drive vehicle at speed greater than 11 km/h (7 MPH) for at least one minute. 4) Warm-up engine above 2,000 rpm.
Does the MIL indicate diag-Recorddiagn nostic trouble code (DTC)? <Ref. to EN(SOHCw/ oOBD)-65 LIST, List of Diagnostic Trouble Code (DTC).>
Record diagnostic trouble code. Repair the trouble cause. <Ref. to EN(SOHCw/ oOBD)-68 Diag­nostic Procedure with Diagnostic Trouble Code (DTC).>
Turn ignition switch to OFF. Disconnect read memory connec­tor and test mode connector. Com­plete clear memory mode.
EN(SOHCw/oOBD)-31