GENERAL DESCRIPTION
Ignition
1. General Description
S151001
S151001E49
A: SPECIFICATIONS
Item
Designation
Ignition coil and ignitor assembly
Model
FH0137
Manufacturer
DIAMOND
Primary coil resistance
0.73Q±10%
Secondary coil resistance
12.8 kQ+15%
Insulation resistance between primary terminal and case
More than 10 MQ
Spark plug
Type and manufacturer
RC10YC4.......... CHAMPION
Alternate BKR5E-11 .......... NGK
Thread size mm
14, P = 1.25
Spark gap mm (in)
1.0-1.1 (0.039 - 0.043)
IG(SOHC)-2
GENERAL DESCRIPTION
Ignition
B: COMPONENT
S151001A05
for_01_18-2.jpg
(1)    Sparkplug
(2)    Spark plug cord (#1, #3)
(3)    Ignition coil and ignitor ASSY
(4) Spark plug cord (#
Tightening torque: N-m (kgf-m, ft-lb) T1: 21 (2.1, 15) T2: 6.4 (0.65, 4.7)
removal, installation, disassembly, and replace­ment.
-   Be careful not to burn your hands, because each part on the vehicle is hot after running.
-   Be sure to tighten fasteners including bolts and nuts to the specified torque.
-   Place shop jacks or safety stands at the speci­fied points.
-   Before disconnecting electrical connectors of sensors or units, be sure to disconnect negative terminal from battery.
C: CAUTION
S151001A03
-  Wear working clothing, including a cap, protec­tive goggles, and protective shoes during opera­tion.
-   Remove contamination including dirt and corro­sion before removal, installation or disassembly.
-   Keep the disassembled parts in order and pro­tect them from dust or dirt.
-   Before removal, installation or disassembly, be sure to clarify the failure. Avoid unnecessary
IG(SOHC)-3