CRANKSHAFT PULLEY
Mechanical
13. Crankshaft Pulley
S153098
CAUTION:
If the tightening angle of crankshaft pulley bolt
is less than 45 degrees, the bolt should be
damaged. In this case, the bolt must be
replaced.
(1)   Replace the crankshaft pulley bolts and clean them.
Crankshaft pulley bolt: 12369AA011
(2)  Clean the crankshaft thread using an air gun.
(3)  Tighten the bolts temporarily with tightening torque of 44 Nm (4.5 kgf-m, 33 ft-lb).
(4)  Tighten the crankshaft pulley bolts keeping them in an angle between 45 degrees and 60 degrees.
CAUTION:
Conduct the tightening procedures by confirm­ing the turning angle of the crankshaft pulley bolt referring to the gauge indicated on the belt cover.
4) Install A/C belt tensioner.
A: REMOVAL
S153098A18
1)   Remove V-belt. <Ref. to ME(SOHC)-42, REMOVAL, V-belt.>
2)   Remove crankshaft pulley bolt. To lock crankshaft, use ST.
ST 499977300 CRANKSHAFT PULLEY WRENCH
for1_211_277-67.jpg
3) Remove crankshaft pulley.
B: INSTALLATION
S153098A11
for1_211_277-68.jpg
1)   Install crankshaft pulley.
2)   Install pulley bolt.
To lock crankshaft, use ST. ST 499977300 CRANKSHAFT PULLEY WRENCH
(1)  Clean the crankshaft pulley thread using an air gun.
(2)  Apply engine oil to the crankshaft pulley bolt seat and thread.
(3)  Tighten the bolts temporarily with tightening torque of 44 Nm (4.5 kgf-m, 33 ft-lb).
(4)  Tighten the crankshaft pulley bolts.
Tightening torque:
127 Nm (13.0 kgf-m, 94.0 ft-lb)
5) Install A/C belt.
for1_211_277-69.jpg
for1_211_277-70.jpg
C: INSPECTION
S153098A10
1)   Make sure the V-belt is not worn or otherwise damaged.
2)  Check the tension of the belt. <Ref. to ME(SOHC)-43, INSPECTION, V-belt.>
3) Confirm that the tightening angle of the crank­shaft pulley bolt is 45 degrees or more. If not, con­duct the following procedures.
ME(SOHC)-44