V-BELT
Mechanical
12. V-belt
S153080
3)   Remove the A/C belt.
4)   Remove the A/C belt tensioner.
A: REMOVAL
S153080A18
for1_211_277-60.jpg
1. FRONT SIDE BELT
NOTE:
Perform the following procedures 1) to 4) with the
engine installed to the body.
1) Remove V-belt cover.
for1_211_277-61.jpg
B: INSTALLATION 1. FRONT SIDE BELT
S153080A11
S153080A1101
CAUTION:
Wipe off any oil or water on the belt and pulley.
1)   Install a belt, and tighten the slider bolt so as to obtain the specified belt tension <Ref. to ME(SOHC)-43, INSPECTION, V-belt.>
2)  Tighten the lock bolt (A)
3)  Tighten slider bolt (B).
Tightening torque: Lock bolt through bolt:
25 N-m (2.5 kgf-m, 18 ft-lb) Slider bolt:
8 N-m (0.8 kgf-m, 5.5 ft-lb)
2)   Loosen the lock bolt (A).
3)   Loosen the slider bolt (B).
4)   Remove the front side belt (C).
for1_211_277-62.jpg
for1_211_277-63.jpg
2. REAR SIDE BELT
S153080A1802
1)   Loosen the lock nut (A).
2)   Loosen the slider bolt (B).
for1_211_277-64.jpg
4) Install V-belt cover. 2. REAR SIDE BELT
S153080A1102
1) Install a belt, and tighten the slider bolt (B) so as to obtain the specified belt tension. <Ref. to ME(SOHC)-43, INSPECTION, V-belt.>
ME(SOHC)-42
V-BELT
Mechanical
2) Tighten the lock nut (A).
Tightening torque: Lock nut (A);
22.6 Nm (2.3 kgf-m, 16.6 ft-lb)
for1_211_277-65.jpg
C: INSPECTION
S153080A10
1)   Replace belts, if cracks, fraying or wear is found.
2)  Check drive belt tension and adjust it if neces­sary by changing generator installing position and/or idler pulley installing position.
Belt tension (A)
replaced: 7-9 mm (0.276 - 0.354 in) reused: 9-11 mm (0.354 - 0.433 in) (B)*
replaced: 7.5 - 8.5 mm (0.295 - 0.335 in) reused: 9.0 - 10.0 mm (0.354 - 0.394 in)
for1_211_277-66.jpg
C/P Crankshaft pulley
GEN Generator
P/S Power steering oil pump pulley
A/C Air conditioning compressor pulley
I/P Idler pulley