FUEL TANK
Fuel Injection (Fuel Systems)
20. Fuel Tank
S155053
8) Disconnect two-way valve hose (A) from two-way valve and disconnect canister hose (B) from canister.
A: REMOVAL
S155053A18
WARNING:
-  Place "NO FIRE" signs near the working area.
-  Be careful not to spill fuel on the floor.
1)  Set vehicle on the lift.
2)   Release fuel pressure. <Ref. to FU(SOHC)-52, RELEASING OF FUEL PRESSURE, OPERATION, Fuel.>
3)   Drain fuel from fuel tank. <Ref. to FU(SOHC)-52, DRAINING FUEL, OPERATION, Fuel.>
4)   Remove rear seat.
5)   Disconnect connector of fuel tank cord to rear harness.
for01_10_20-1.jpg
9) Loosen clamp and disconnect fuel filler hose and air vent hose from fuel filler pipe.
for01_10_20-2.jpg
for01_10_20-3.jpg
6) Push grommet which holds fuel tank cord on floor panel into under the body.
10)  Move clips, and disconnect quick connector. <Ref. to FU(SOHC)-69, REMOVAL, Fuel Delivery, Return and Evaporation Lines.>
11)   Disconnect fuel hoses.
for01_10_20-4.jpg
for01_10_20-5.jpg
7) Remove rear crossmember. <Ref. to RS-20, REMOVAL, Rear Crossmember.>
FU(SOHC)-55
FUEL TANK
Fuel Injection (Fuel Systems)
12) Support fuel tank with transmission jack, remove bolts from bands and dismount fuel tank from the vehicle.
WARNING:
A helper is required to perform this work.
4) Connect fuel filler hose and air vent hose.
for01_10_20-6.jpg
for01_10_20-7.jpg
5) Connect fuel hoses, and hold then with clips and quick connector. <Ref. to FU(SOHC)-69, REMOVAL, Fuel Delivery, Return and Evaporation Lines.>
B: INSTALLATION
S155053A11
for01_10_20-8.jpg
1)  Support fuel tank with transmission jack and push fuel tank harness into access hole with grom-met.
2)  Set fuel tank and temporarily tighten bolts of fuel tank bands.
WARNING:
A helper is required to perform this work.
for01_10_20-9.jpg
6) Tighten band mounting bolts.
Tightening torque:
33 Nm (3.4 kgf-m, 25 ft-lb)
for01_10_20-10.jpg
3) Connect two-way valve hose (A) to two-way valve and connect canister hose (B) to canister.
for01_10_20-11.jpg
7) Install rear crossmember. <Ref. to RS-20, INSTALLATION, Rear Crossmember.>
FU(SOHC)-56
FUEL TANK
Fuel Injection (Fuel Systems)
8) Connect connectors to fuel tank cord and plug service hole with grommet.
for01_10_20-12.jpg
9)  Set rear seat and floor mat.
10)  Connect connector to fuel pump relay.
for01_10_20-13.jpg
C: INSPECTION
S155053A10
1)   Make sure there are no cracks, holes, or other damage on the fuel tank.
2)   Make sure that the fuel hoses and fuel pipes are not cracked and that connections are tight.
FU(SOHC)-57