for01_10_19.htm

FUEL

Fuel Injection (Fuel Systems)

3) Disconnect battery ground cable.

S155052

19. Fuel

A: OPERATION

S155052A16

1. RELEASING OF FUEL PRESSURE

S155052A1601

WARNING:

- Place "No fire" signs near the working area.

- Disconnect ground terminal from battery.

1) Disconnect connector from fuel pump relay.

4) Remove the floor box located just behind the rear seats.

5) Remove access hole lid.

2) Start the engine, and run it until it stalls.

3) After the engine stalls, crank it for five more seconds.

4) Turn ignition switch OFF.

2. DRAINING OF FUEL _S15505

WARNING:

- Place "No fire" signs near the working area.

- Be careful not to spill fuel on the floor.

1) Release fuel pressure. <Ref. to FU(SOHC)-52, RELEASING OF FUEL PRESSURE, OPERATION, Fuel.>

2) Open fuel flap lid, and remove fuel filler cap.

6) Disconnect connector from fuel pump.

7) Disconnect quick connector, and then disconnect fuel delivery hose (A). <Ref. to FU(SOHC)-69, REMOVAL, Fuel Delivery, Return and Evaporation Lines.>

FU(SOHC)-52

FUEL

Fuel Injection (Fuel Systems)

8) Move clips, and then disconnect fuel return 12) Remove service hole cover, hose (B) and jet pump hose (C).

13) Disconnect connector from fuel sub meter.

14) Disconnect fuel jet pump hose.

9) Remove nuts which install fuel pump assembly onto fuel tank.

15) Remove bolts which install fuel sub meter unit on fuel tank.

10) Take off fuel pump from fuel tank.

11) Drain fuel from fuel tank by using a hand 16) Remove fuel sub meter unit, pump.

WARNING:

Do not use a motor pump when draining fuel.

FU(SOHC)-53



	FUEL Fuel Injection (Fuel Systems)

	17) Drain fuel from there. WARNING: Do not use a motor pump when draining fuel.



	FU(SOHC)-54